Jr. Radio Frequency (RF) Engnineer
- Military veterans preferred
2019-06-12 SAIC (www.saic.com)
Huntsville Alabama 35898 United States
SAIC has a need for a Junior-Level Radio Frequency Engineer to provide engineering support at Systems Simulation Software and Integration (S3I) to support testing in a reconfigurable Avionics System Integration Laboratory (ASIL).
This position will require the selected candidate to be able to incorporate continuous and pulsed RF signals through antennas, connector, cables and processors in the arena of GPS navigation, transponder and Identification Friend or Foe (IFF).
The laboratory seeks to replicate in laboratory rack mounted form the equivalent functionality that is found in several aircraft series used in the Special Electronic Mission Aircraft (SEMA) fleet.
The FW ASIL includes aircraft bus 1553 and ARINC 429 channels that may be monitored simultaneously with the RF signal. Direct experience with army aviation equipment considered a plus.
Conduct research and recommend for provisioning suitable RF cable and connectors that will interconnect subsystems. This shall include additional test equipment if so needed
Operate laboratory equipment in the manner of waveform analysis for timing and distortion of signal and use laboratory equipment to inject replicated signals
Conduct signal analysis for signal strength and integrity, waveform distortion and bandpass limitation or signal throughput using spectrum analyzers, network analyzers, oscilloscopes and signal generators
Interface with diverse government agencies in the manners of frequency allocation, approval and certification for airspace and signal management. Signal delay from the RF subsystems would be an important data product
TYPICAL EDUCATION AND EXPERIENCE:
Bachelors and two (2) years or more experience; Masters and 0 years related experience.
Proficient in the MS Office series of products of Word, Power Point, Excel, Outlook and Visio
Experience writing technical reports
Capable of working independently without continuous oversight after receiving initial training
Demonstrated self-starter with strong interpersonal communications skills and ability to work across geographically diverse groups
Estimated Travel: <10%
Clearance: Secret clearance is required to perform this work.
Experience or studies related to navigation, identification or communication
Experience working with Labview
Academic or work experience directly related to aircraft wiring