Corrosion Control Specialist (Whidbey P3/P8) - Military veterans preferred

2019-09-07
Kellogg Brown & Root (www.kbrjobs.com)
Other

/yr

  full-time   employee


Oak Harbor
Washington
98277
United States

Description

The selected candidate will provide on-site academic instruction and on-equipment proficiency training to Navy and Marine Corps personnel, technical specialist, and other Government employees, on the prevention, inspection and treatment of corrosion on Navy and USMC aviation platforms and systems.

Assist, train, and demonstrate the best methods of prevention, inspection and treatment of corrosion. Provide advice on supply support problems, and/or cross-reference of manufacturer-to-Navy part numbers.

Assist the Government in developing training plans and identifying corrosion control training programs, which will ensure Navy and Marine Corps personnel are trained to prevent, inspect and treat corrosion.

Provide advice on the identification of, and instruction on the use of special tools, handling equipment, and test equipment associated with and related to corrosion control.

Provide technical advice and assistance in accident investigations, failure data reports, and material deficiency reports. Provide corrosion control information to operations and maintenance personnel.

The Equipment Specialist will provide on-site technical support to operating units, commands and shore-based industrial activities to analyze and identify corrosion control discrepancies in maintenance procedures contained in the most current versions of technical manuals for weapon systems/equipment; compare performance of actual weapon systems/equipment corrosion control procedures against the corrosion control procedures documented in these weapon systems/equipment technical manuals.

Provide recommended changes to existing weapon systems/equipment corrosion control technical manuals in technical reports for use by the Government in preparing Technical Publications Deficiency Reports.

Perform evaluation of maintenance occurrences to the criteria identified in the weapon systems/equipment TMs to ensure conformance with weapon systems/equipment corrosion control objectives; determine the cause of weapon systems/equipment corrosion damage and other corrosion related problems and recommend corrective actions to the Government.

Perform on-site analysis of weapon systems/equipment corrosion control deficiencies/failures, in accordance with the requirements of appropriate technical manuals and provide advice on the development of resolutions.

A Secret security clearance is required

Education/Experience: A High School diploma or GED and Technical Training in a relevant technical field is required along with six (6) years of practical hands-on experience within the past seven (7) years. Two (2) years of this experience must beat or above the military E5 levelor non-military equivalent experience: Senior Journeyman level, Senior Electronics or Engineering Technician level, etc. is acceptable.

Optional sources include: - Navy A and/or C schools or service equivalent schools- Accredited Vocational Education Institutions- OEM/Factory technical training programs related to the system(s)/ equipment being supported

Preferred experience working on P-3 or P-8 aircraft.

Preferred experience working on the following:air-frame, fuselage compartments, alighting/launching system, flight controls, escape systems, turboshaft engines, turbojet engines, APUS, helicopter drives/transmissions, turbofan engines, power plant installation, a/c/prsrz/ice control/environmental control systems, elect/lighting systems, hydraulic systems, fuel systems, and/or oxygen systems.

Additional Notes: This position may be required to work or travel to sites which could include environments that are located at or near weapons magazine areas, flight decks, flight-line ramps, aircraft spots, combat zones, and weapon ready-service areas.

EOE/Minorities/Females/Vet/DisabilityApplication Instructions For immediate confidential consideration, please apply online by clicking Apply Now to Join Our Team.

Qualifications

A Secret security clearance is required

Education/Experience: Bachelor's degree and 2 years of experience or in lieu of a degree a High School diploma or GED and Technical Training in a relevant technical field is required along with six (6) years of practical hands-on experience within the past seven (7) years. Two (2) years of this experience must beat or above the military E5 levelor non-military equivalent experience: Senior Journeyman level, Senior Electronics or Engineering Technician level, etc. is acceptable.

Optional sources include: - Navy A and/or C schools or service equivalent schools- Accredited Vocational Education Institutions- OEM/Factory technical training programs related to the system(s)/ equipment being supported

Preferred experience working on P-3 or P-8 aircraft.

Job: Aircraft Systems

Primary Location: US-US-WA-Oak Harbor

Req ID: 1085275